Lyophilisation: why a peptide arrives as a powder

A peptide almost always arrives in the vial as a white, dry powder or a compact white mass that specialists call a cake. This form is no accident. It is the result of lyophilisation, or freeze-drying, the same process used to preserve many sensitive biological materials.
Why the water is removed
In water, a peptide slowly degrades. Peptide bonds can break (hydrolysis), some amino acids change their chemical form, asparagine through deamidation for example, and microorganisms can multiply in solution. Once the water is removed, all these reactions slow down drastically. A dry peptide is more stable, easier to transport and keeps longer.
A peptide could also be dried by heating, but heat damages sensitive molecules. Lyophilisation removes water at low temperature.
The three stages of freeze-drying
1. Freezing
The peptide solution is dispensed into vials, and the rubber stoppers are inserted only halfway, leaving openings through which vapour can escape. The shelves of the freeze-dryer are cooled far below zero, often to around -40 °C or lower. The water turns into ice crystals, and the peptide is trapped between them. The size of these crystals later determines the pores in the cake.
2. Primary drying
The chamber is evacuated to a very low pressure and the shelves are gently warmed. At such low pressure, ice does not turn into liquid but directly into vapour. This is sublimation. The vapour is captured on a cold condenser. This is the longest stage and can last more than a day. Throughout, the product must remain below the temperature at which its structure would collapse.
3. Secondary drying
Once the ice is gone, water bound to the molecules remains in the material. The temperature is raised, and this water is gradually removed as well. Residual moisture is usually brought down to a few percent or less.
Finally, the stoppers are pushed fully home while the vials are still inside the chamber, under vacuum or in a nitrogen atmosphere. Only then does the vial leave the machine and receive its aluminium cap.
What the look of the cake tells you, and what it does not
A uniform, porous cake is a sign that the cycle was run properly. But appearance alone does not prove quality:
- A cake that has pulled away from the wall of the vial or cracked is usually just a cosmetic matter.
- Powder instead of a cake usually means the cake broke up during transport, which the jolting of a parcel can easily cause.
- A shrunken, glassy or "melted" cake can point to too much moisture or a fault in the cycle. That is a reason to have the batch checked.
With very small quantities, for example a few milligrams of peptide in a vial, the cake may be a thin layer that is barely visible. That is normal, since the mass involved is smaller than a grain of rice.
What mannitol is for
Some peptides are lyophilised with added mannitol. Mannitol is a sugar alcohol used in pharmaceutics as a bulking agent. It gives the cake structure and firmness, especially when there is little peptide, and helps the cake dry evenly.
Mannitol does not replace the peptide. The amount of peptide stated on the label should refer to the peptide itself, not to the total mass of the cake, and the addition of mannitol should be clearly declared. Mannitol is invisible to the UV detector, so it does not affect the HPLC purity result.
Lyophilisation and transport
A lyophilised peptide is considerably more robust than a solution, so as a rule it is shipped as a powder. How long and at what temperature it can travel without cooling is explained in our article Does a peptide spoil in transit without cooling?
View catalog