Does a peptide spoil in transit without cooling? Facts and myths

A common question is why a parcel containing a peptide does not travel in a refrigerator. The short answer: a lyophilised peptide does not need cooling for a few days in transit. The longer answer depends on the chemistry of the peptide itself, and this is where myths and facts easily get mixed up.
Myth: "A peptide must be kept cold at all times, or it degrades"
Storage recommendations, usually -20 °C for long-term storage, refer to months and years. A lyophilised peptide is dry, and without water most of the chemical reactions that break it down proceed very slowly. That is why manufacturers, as a rule, ship lyophilised peptides at room temperature. For most peptides, a few days at room temperature are not a problem.
The exception is extreme heat. A parcel that sits for hours in a hot vehicle in the middle of summer can reach temperatures at which degradation proceeds faster. How much faster depends on the peptide itself.
Myth: "Only temperature matters"
For a dry peptide, moisture is a bigger enemy than heat. Many peptides are hygroscopic, meaning they absorb water from the air, and with moisture the reactions that lyophilisation halted come back.
The most common mistake is therefore not transport but opening a cold vial. When a vial is taken out of the refrigerator or freezer and opened straight away, moisture from the warm air condenses on the cold powder. The rule is: before opening, the vial should be allowed to warm up to room temperature, and it should be stored closed in a dry, dark place.
Fact: not all peptides are equally sensitive
Stability depends on the sequence. Several amino acids and combinations of them are known weak spots:
- Methionine, cysteine and tryptophan oxidise easily on contact with oxygen.
- Asparagine and glutamine can lose their amide group (deamidation), asparagine especially when it is followed by glycine in the chain.
- Glutamine at the very start of the chain can close into a ring and turn into pyroglutamate.
- The bond between aspartic acid and proline is more prone to cleavage than other bonds.
A peptide without these weak spots is, as a rule, more robust. A peptide with several of them deserves more care both in transport and in storage.
Fact: a solution is much more sensitive than a powder
Everything that applies to a powder applies many times over to a solution. In water, hydrolysis, deamidation and oxidation speed up, and microorganisms can multiply. That is why a solution is kept cold and not stored for long. Repeated freezing and thawing also harms a peptide, which is why laboratories divide a solution into smaller portions and thaw only as much as is needed.
How stability is actually tested
Stability is not assessed by feel but by measurement. Samples from the same batch are stored at different temperatures and humidities and re-analysed by HPLC at intervals. Accelerated studies under the international guideline ICH Q1A use 40 °C and 75% relative humidity, precisely in order to show in a shorter time what happens. Degradation products appear as new peaks in the chromatogram, so the change shows up as a drop in HPLC purity.
When the parcel arrives
- Put the vial away in a cold, dry and dark place, as stated on the label.
- Before opening, wait until it has warmed up to room temperature.
- Check that the vial and its closure are undamaged. If something was damaged in delivery, photograph the damage and contact us within 48 hours, as set out in our return policy.